Snake plants are definitely something you should have in your life and around your home. A popular, and especially easy-to-grow houseplant is the snake plant, also known as sansevieria or mother-in-law’s tongue. The good news is that you don’t have to buy new snake plants because you can propagate them from cuttings. To learn more about how to populate snake plant and growing snake plants at home and with friends, read on.
Propagating Snake Plant
How to Populate Snake Plant in Water
populate snake plant cuttings in water is the easiest method for propagating it. If you have ‘off’ leaves that bend or break, this is a great way to utilize them. When you want to change the appearance of your snake plant, you can also use those extra leaves you prune away.
Carefully cut the leaf you want to propagate near the soil with a sharp knife or scissors. Better results are achieved if your cuts are sharp and clean. Root hormone can be dipped into the cutting if you like. In the next step, cover about 25% of the leaf with water, starting from the bottom up.
As demonstrated above, if your snake plant leaves are large, you can cut them into sections, then place each section into water.The leaf must be kept facing the same direction it was when it was in soil. Considering that leaves are highly polar, they will only grow roots if they are immersed in water at the point closest to the soil. Incorrect orientation of a leaf will prevent the leaf from growing roots.
The bottom of the cutting should be cut in a V shape. This serves a number of purposes and increases the success rate of my cuttings. This increases the surface area of the cut edge exposed to the water, prevents the cut edge from pressing against the bottom of the glass, and helps me identify the bottom end of the leaf if I get confused at any time.
A mason jar or tall vase will be ideal for holding large leaves, like those on snake plants. In a warm room with indirect light, keep the leaf. You should change the water in the glass or vase every week, or when the water appears cloudy.
The process of seeing roots develop will take quite some time. Typically, roots will not sprout from your cutting until two months have passed. From the roots, you may also see some small growths or shoots.
Your cutting can be planted in soil once its roots sprout. The cutting should be inserted deep enough to reach the water line on the leaf. You don’t need to worry about the small shoots. They’ll pop right up through the soil when they’re ready.
The plant will receive some indirect light, but the process is the longest if not enough indirect light is available.
Propagating Snake Plant in Soil
If you root those cuttings directly in the soil, you can get more cuttings from a single leaf. Make a clean and sharp cut along the soil line of the leaf you want to propagate. After cutting the leaf into pieces using a very sharp knife, each piece should be about 2 inches long.
Leave the leaf pieces out for a few days until they callous over. Succulents can become infected by soil bacteria, resulting in rot if they are not properly maintained.
Propagating by Division
You can propagate snake plants by division if you need more quickly. Plants are separated into two or more plants through this process. Slide your plant out of its pot by gently laying it on its side. Putting down some newspaper or doing it outside may be a good idea.
Consider where the rhizomes are by looking at the roots carefully. You would probably only separate it in half if your plant was small, but if your plant was large, you could divide it longer. Make sure that each section of the plant has at least three rhizomes and a healthy leaf — you can use a handsaw or even sharp shears.
Sum Up
you don’t need to buy new snake plant if you want new snake plant. All you need to do is learn how to populate snake plant and make more snake plant for your collection. there are some way you can choose in how to populate snake plant