Mother-in-law plant (Sansevieria) is also known as the snake plant because of its tall, slender, erect leaves. If drooping snake plant happened, it’s a sign that something isn’t quite right. Continue reading for more on the causes and treatments for a mother-in-law tongue with drooping leaves.
Causes of Drooping Snake Plant: Improper Watering
The succulent plant mother-in-tongue law’s has thick, moisture-retaining leaves. The plant can live in its natural environment, which is arid, rocky regions of the West African tropics, thanks to the built-in watering system. The snake plant, like many succulents, is prone to root rot in wet conditions, and droopy snake plant leaves are common when the plant is overwatered.
When the top 2 or 3 inches (5-7.5 cm) of soil is entirely dry, water the snake plant deeply until water runs through the drainage hole. Regardless of the circumstances, a plant near a heat vent or a sunny window will require more frequent watering. Many people, however, find that watering every two or three weeks is plenty.
Allow the pot to drain freely before reinstalling it on the drainage saucer by watering around the inside border of the pot to keep the leaves dry. Wait until the top of the soil is completely dry before watering again. Water carefully during the winter months, only when the leaves appear to be wilting. It’s typically adequate to do it once a month.
Also, make sure the plant is in a drainage-hole-equipped container. To improve drainage, use a fast-draining potting mix, such as a cactus and succulent mix, or a conventional potting soil with a handful of coarse sand perlite.
Causes of Drooping Snake Plant: Lighting
Some joke that Sansevieria is so resilient that it can thrive in a closet, although prolonged darkness over lengthy periods of time can cause droopy snake plant leaves. When the plant is exposed to light, the design on the leaves becomes more vibrant and noticeable.
Snake plants withstand bright light, but direct light from a south-facing window may be too harsh, causing the mother-in-tongue law’s to droop. During the winter, though, a southern exposure is ideal. Almost any time of year, a sunny west- or east-facing window is a good option. A north-facing window is acceptable, but prolonged exposure to the north may result in droopy snakes.
Repotting
Check to determine whether the plant is rootbound if improper watering or lighting isn’t the cause of the drooping mother-in-tongue. law’s Keep in mind, though, that snake plants only require repotting every three to five years. Because a too-large pot stores an excessive amount of potting soil, which can cause root rot, move the plant to a container that is only one size larger.
How Cure Drooping Snake Plant Leaves
You may be able to revive your snake plant leaves to some extent by following the instructions above, depending on how badly they are drooping. However, if they are in poor condition, you will most likely be unable to repair the existing leaves. You can either let them alone until new, upright growth appears, then cut them off, or simply leave them alone until new growth takes over and they die on their own.
Dead or rotten leaves should be clipped off just below the decaying or dead section. Keep in mind that the chopped leaves’ tips will never regenerate. If you remove too much of the leaf mass, the plant may perish because there isn’t enough light being photosynthesized to allow it to thrive.
It’s preferable to wait for fresh, healthy growth to appear before chopping off the old leaves, as this will help your plant recover much faster.
If you follow the above instructions for reviving your drooping snake plant, you should never have troubles with it again.
If you’ve ever been disappointed because one of your houseplants became sick or died and you weren’t sure why, I can assist you.