Is My Snake Plant Dying?
All plants need roots to thrive, but your snake plant has no roots. Perhaps you received the snake plant in this condition from a gardening supply store, or perhaps a friend or coworker did. You must be wondered how to save it or do they can still alive without roots, right? Before we are going deeper, know the reasons why your snake plant has no roots.
Why The Snake Plant Has No Roots?
Overwatering caused your snake plant’s roots to rot away, which is why it doesn’t have any. Snake plants are usually devoid of roots due to overwatering or a fungus that has attacked and killed the roots beneath the soil. But you don’t need to be worried. Fortunately, you can regrow the snake plant by propagating methods. The first symptom is we can indicate on the leaves.
What Happens With The Leaves?
As long as our snake plant has no roots, the leaves of certain snake plants are tilting over and becoming floppy, according to some indoor gardeners. This will not affect all of the leaves, but it will affect a few of them. There’s no denying that there’s an issue. The snake plant has rhizomes, which are underground stems that can develop adventitious roots, branches, and leaves. The water you pour in the pot will be retained by the rhizomes, roots, and leaves of your snake plant.
What’s The Best Solution?
The best solution for the snake plant that has no roots is, propagate it. Like we mentioned before, propagate is the best way to solve the problems of snake plant has no roots. We would like to share with you how to propagate the snake plants, this is a way to save your snake plant.
Propagate Snake Plant With The Leaves
When your snake plant reaches this stage which is snake plant has no roots, it’s very much dead. After all, root rot has set in, and the roots have died as a result of a lack of oxygen. It’s a miracle your houseplant is still alive; most other plant species would be extinct. This one can be attributed to the snake plant’s hardiness, as previously stated. It’s feasible to produce fresher, healthier snake plants from the leaves of your current decaying snake plant.
Remove The Dead Leaves
Trim any ends of the leaves that appear to be frayed using sterilized gardening shears. If they’re just starting to rot, they’ll be yellowed. They can also be dark brown or black in color. The injured snake plant leaf ends have been reported to be “melted” by some indoor gardeners. Make little snips, being careful to remove any dead sections. It’s fine to cut into the healthy, green section of your snake plant leaves to avoid getting too close to the rotted ends, but don’t go any higher than that.
Fungus Treatment for Your Leaves
It’s possible that your snake plant has no roots because of a fungal illness that has spread throughout the plant and killed the roots. If that’s the case, the methods outlined here may not be enough to save the houseplant. You could still want to go ahead and do it. Cinnamon, which you probably already have in your pantry, can help prevent fungus from growing on your fresh leaves. Apply a couple pinches of cinnamon to the ends of your leaves. Then, for at least 24 hours, leave them alone.
Potting Mix
While the leaf ends are being prepped, you can work on the next step of the process, or make a homemade potting mix out of peat moss and perlite. You’ll need two or three cups of peat moss and two or three cups of perlite in the mix. After that, add a small amount of water until the mixture feels moist but not mushy.
Repotting Time
Fill the pot with potting mix with right pH almost to the top, leaving 34 inches of room under the rim. You can now take your snake plant leaf cuttings and place them in your new pot with the homemade potting mix after the 24-hour period has passed.
Sum Up
Check your plants now! If your snake plant has no roots, we are suggesting you to try those steps. However, propagation doesn’t always work, and it’s not always because of your actions. It’s enough if just a couple of the leaves take root. They’ll grow new leaves on their own, and your snake plant will survive. Even if that doesn’t work out, you’ve given it your all. Hope this article helps!